Description

Features

• 24 V digital trigger input
• ARM®9 32-bit processor
• 64 MB onboard SDRAM for storing data
• Robust standardized metal housing
• Power Save Mode: Reduced power consumption when no acquisition runs

Counter

• 4 x 32-bit incremental counter inputs (MSX-E1701), max. 5 MHz, or 8 x PWM outputs, can be configured through firmware
• 4 x 32-bit sin/cos counter inputs with 1Vpp (MSX-E1711) or 11 µApp (MSX-E1721), 250 kHz
• Voltage supply of the sensors through M23 female connector (24 V or 5 V)
• Single, double, quadruple edge analysis (MSX-E1701)
• Compare logic
• Status LEDs for incremental counter inputs

Digital I/O

• 8 x 2 digital lines, 24 V, which can be parameterised as pairs of inputs or outputs
• Shutdown logic
• Watchdog for resetting the outputs to “0“
• At Power-On the outputs are set to ”0“
• Electronic fuse
• Dual LED for each 24 V digital I/O with direction indication

Safety features

• Status LEDs for fast error diagnostics
• Optical isolation
• Input filters

Interfaces

• Fast 24 V trigger input
• Ethernet switch with 2 ports
• Synchronisation/trigger In/Out
• Line in for 24 V supply and cascading

Communication interfaces

• Web server (configuration and monitoring)
• Command server SOAP for transferring commands
• Data server (TCP/IP or UDP socket) for sending acquisition data
• Event server (TCP/IP socket) for sending system events (Diagnostics such as temperature, short-circuits …)
• Command server Modbus TCP and Modbus (UDP) for sending commands

Synchronisation/time stamp

Time stamp

Several MSX-E systems can be synchronised with one another in the µs range through a synchro connection. This allows to start a synchronous data acquisition, to generate trigger events and to synchronise the time on several MSX-E systems. Furthermore, the systems have a time stamp that logs the point in time at which the data was acquired by the system.

The combination of synchronisation and time stamp (TS) allows the clear allocation of signals that were captured by several systems.

Acquisition modes

Asynchronous acquisition

With the asynchronous acquisition, the digital inputs can be read out via SOAP or Modbus function. For each function call, the values of one channel are transmitted.

Synchronous acquisition

With the synchronous acquisition, the inputs are first initialised and then the acquisition is parameterised. The acquisition runs automatically depending from a trigger source. Either the 24V trigger input or a synchro trigger can be used as trigger source

Onboard programming / stand-alone operation

Development mode

With the Development mode of the MSX-E systems you can customise your measurement, control and regulation applications to fit your requirements. The programs run directly on the MSX-E systems, which has two advantages: external PCs are relieved and you can process data freely according to your requirements. This helps you to improve the efficiency of your processes and to secure your investments.

Safety

Watchdog

The MSX-E1516 Ethernet system has a 16-bit watchdog which can be programmed in 3 time units (µs, ms, s). The watchdog is used for automatically resetting the digital outputs to 0 V after a defined time in order e. g. to switch off actuators if an error has occurred.

ConfigTools

The ConfigTools program allows an easy administration of the MSX-E systems. These are automatically detected in the network. ConfigTools
consists of common and specific functions. In addition, with ConfigTools, the complete configuration of a MSX-E system can be saved and transferred to another system of the same type (clone function). ConfigTools is included in the delivery

ConfigTools functions for MSX-E3011:

• Change of IP address
• Display of web interface
• Firmware update
• Save/load system configuration
• Save/load channel configuration
• Monitor for analog inputs